|
|
|
|
|
|
140403
|
|
|
|
| |
For Universal Applications- High-output coils for use in either 2- or 4-cylinder motorcycles
- Motorcycles with point or electronically triggered ignitions use PART #140403 or #140403S
- Bikes equipped with capacitive discharge ignition (CDI) use PART #140404 or #140404S
- ACCEL engineers designed these coils’ special low-resistance primary winding to match the operating characteristics of factory and aftermarket CDI systems
- Maximum performance with fast rise times
- Extra-heavy-duty 9mm silicone
NOTE: Using the wrong coil may damage your motorcycle's electronic ignition module. To determine your ignition type, complete the following test:
1. Determine whether the type of coil you are replacing is a high tower coil. (These coils will NOT replace single tower coils.)
2. Using a volt meter or 12V test light, hook the positive lead to the positive post and the negative lead to the ground on one of the stock coils.
3. Turn the ignition on, but DO NOT engage the starter button.
4. If there are 12V at the coil, the motorcycle has an inductive type ignition. If there is no voltage at the coil, then the motorcycle has a CDI ignition because the power goes to the control box first.
|
|
|
