Works well in wet conditions as well as in cold brake conditions
Will withstand abrupt temperature changes allowing for a quick feel return
Advance Ceramic Full Metallic HH Compound
Will withstand friction ratings of 0.7u and does not require any heat to deliver friction
Advance ceramic technology allows for pads to “cool off” as soon as pressure is released from the brake lever
Requires very little brake pressure effort under repeated braking
Recommended for those looking for the “edge” or “ultimate” stopping feel and controlNote: All Galfer brake pads must be properly “Bedded-In” to achieve maximum output and reduce unnecessary rotor wear.
Galfer strongly recommends following these Bed-In directions:
1. Clean the brake rotor(s) with thin sand paper and water prior to new pad installation
2. Towel dry the rotor surface after sanding
3. Install the new pads and be easy with the brakes for the next 40-50 miles
